Difficulty/Skill Level: Some steps may be physically challenging. Professional installation is recommended.
Tools/Materials: Tie wraps, plastic trim tool (optional)
Please read all instruction steps before starting.
Installation is completely reversible. No permanent modifications are made to your car.
Professional installation is recommended.
Prior to installing the skins, make sure all pieces are present and no damage or defects are present. There should be two bottom skins and two back skins.
It is highly recommended that the seats be removed from the car to install the skins. There is enough seat belt length to allow taking the seat completely out of the car without disconnecting the seat belt. The seat can be placed on a tarp or other protective covering on the ground beside the car. This will make the installation far easier!
Work gently and slowly. Do not use excessive force. Excessive force may result in damage to the skin. Damage caused by excessive force is not covered by warranty.
If you have a question give us a call at (858) 939-9506.
Place skin on seat bottom.
Tuck Velcro straps between seat and back.
Guide straps rearward. Note: You may have to unhook the seat debris shield to get access.
Wrap the straps over the seat bar.
Tug lightly on the straps and squeeze the Velcro together.
At the front of the seat, locate the seat skin's center strap. Note: There will be a grommet or loop in this strap.
Use a tie wrap to connect the center strap to the underside of the seat.
Pull the tie wrap tight.
Cut off the end of the tie wrap.
Slide the side strap under the seat plastic.
Stick the two Velcro straps together.
Locate the corner grommet.
Slide seat material with grommet under side plastic.
Insert tie wrap as shown.
Slide tie wrap through grommet and tighten.
Cut tie wrap end.
Slide pads under seat side plastic.
Slide remaining skin material under seat side plastic.
Check that everything is attached.
Re-tighten all Velcro straps to make sure seat skin is tightly held.
Re-attach the seat debris cover.
Configure seat skin back as shown.
Slide skin over the seat back. Work the skin down all the way.
Guide the back nylon straps between the seat back and the seat bottom.
Guide the straps to each side of the seat debris flap.
Attach the strap's male buckles to the female buckles on the backside of the skin. Pull the straps downward to tighten.
Connect the side Velcro straps to each other across the width of the seat back.
Secure the Velcro that goes through the head rest opening by attaching to the inner backside of the skin.
CAUTION: Excessive force can tear the material. Work gently and slowly.
Align the skin to clear the airbag housing. Ensure the skin does not cover the airbag housing!
Tuck the front edge of the skin under the seat belt guide.
Repeat steps for other seat.